TM 5-3895-379-23
ENGINE OIL COOLER REPLACEMENT - CONTINUED
0017 00
REMOVAL
NOTE
Tag and mark hoses to aid in installation.
1.
Loosen two clamps (1) and remove hose assemblies (2) and (3) from oil cooler (4).
2.
Remove connector (5).
NOTE
On CB534B Roller, item 6 is a ring. On CB534C Roller, item 6 is a washer.
3.
Remove connector ring (6) or gasket (6). Discard ring or washer.
4.
Remove oil cooler (4), gasket (8) and rubber housing bushing (9) from oil filter head assembly (7).
5.
Remove gasket (8) from oil cooler (4). Discard gasket.
2
3
1
1
9
7
5
6
4
8
401-256
CLEANING AND INSPECTION
WARNING
Cleaning compound, solvent MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. The use of protective gloves and goggles is
suggested. Use in well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Clean all metal parts with cleaning compound, solvent.
0017 00-2
