TM 5-3895-379-23
VALVE COVER AND BREATHER TUBE REPLACEMENT - CONTINUED
0016 00
INSTALLATION
NOTE
If installing the breather tube only, go to step 4.
Grooved side of gasket must face cylinder head.
1.
For CB534B Roller, position three tabs of new gasket (23) into three notches in valve cover (22).
2.
For CB534C Roller, position new gasket (23) in valve
19
cover (22).
20
CAUTION
21
22
Do not overtighten valve cover nuts. Fail-
ure to follow this caution may cause
rocker bracket nuts being overtightened.
NOTE
Lubricate seals with clean engine oil prior
to installation.
23
3.
Install valve cover (22) and gasket (23) on cylinder
10
head (10) with three seals (21) if damaged, washers
TAB
CB534B
(20) and nuts (19). Tighten nuts to 22 lb-ft (30 Nm).
ROLLER
401-254
4.
Position breather tube (14) through bracket (17).
5.
Feed breather tube (14) from bottom to valve cover connector (15).
6.
Install bracket (17) to engine (18) and tighten screw (16) to 22 lb-ft (30 Nm).
16
18
17
14
401-253
0016 00-4
