TM 5-3895-379-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 6. Vibratory System Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
Vibration Does Not Work In Forward or
2. If 24 to 28 Vdc are not measured
Reverse Travel - Continued.
at wire terminal 1 (wire C926-
BU), press vibration on/off switch
once and try again. If 24 to 28 Vdc
are still not measured at wire
terminal 1 (wire C926-BU) and
VIBE fuse is good, turn engine
start switch to OFF position (TM
5-3895-379-10). Connect harness
connector to solenoid connector.
Close left-side door assembly. Go
to Step 2.
2. Check vibration push switch. 1. If zero ohms followed by infinite
Remove vibration push switch
ohms are not measured as button is
pressed and pressed again, replace
probe of multimeter to terminal
vibration push switch (WP 0080
and negative (-) probe of
multimeter to other terminal.
With multimeter set to measure 2. If zero ohms followed by infinite
ohms are measured as button is
ohms, press button of vibration
pressed and pressed again, go to
push switch several times.
Step 3.
VIBRATION
PUSH SWITCH
WIRE 103-YL
WIRE 932-YL
401-226
0006 00-106
