TM 5-3895-379-23-2
0229
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
Bumper weighs 625 lb (283 kg).
Front side shown, rear side similar.
1.
Attach a lifting device to bumper assembly (Figure 2, Item 3).
2.
Operate lifting device while assistant guides the bumper assembly (Figure 2, Item 3) into position on yoke
assembly (Figure 2, Item 4).
3.
Install six screws (Figure 2, Item 5) and washers (Figure 2, Item 2) in yoke assembly (Figure 2, Item 4) and
bumper assembly (Figure 2, Item 3). Tighten screws to 295-385 lb-ft (400-522 Nm).
NOTE
Replace electrical tiedown straps as required.
4.
Pull wiring harness (Figure 2, Item 1) though hole in backside of bumper assembly (Figure 2, Item 3) and
position for component installation.
2
1
3
3
5
4
1
M1183SWR
Figure 2. Front and Rear Support (Bumpers) Installation.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00167)
