TM 5-3895-379-23-1
0215
ASSEMBLY
1.
If required, install plug (Figure 2, Item 12).
2.
Install new preformed packing (Figure 2, Item 11) and dust cap (Figure 2, Item 10) on driveshaft
(Figure 2, Item 9). Do not tighten cap at this time.
NOTE
If necessary, apply a light coat of grease to splines to help assist in assembly.
Avoid excess force when assembling driveshaft. If splines are damaged the shaft will not
operate correctly when returned to service.
3.
Spline driveshaft (Figure 2, Item 9) and tighten dust cap (Figure 2, Item 10).
WARNING
Wear suitable eye protection during removal of snap rings to protect your eyes in case a
snap ring flies out of universal joint. Failure to follow this warning may cause injury.
Apply a light coat of clean grease inside of bearings prior to assembly.
4.
Install two universal joints (Figure 2, Item 8) on driveshaft with four bearings (Figure 2, Item 1) and snap rings
(Figure 2, Item 2).
5.
Install two universal yokes (Figure 2, Item 3) at ends of driveshaft with four bearings (Figure 2, Item 5) and
snap rings (Figure 2, Item 4).
6.
Position driveshaft on roller and install eight new lockwashers (Figure 2, Item 6) and bolts (Figure 2, Item 7)
on universal yokes (Figure 2, Item 3).
0215-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00153)
