TM 5-3895-379-23-1
0215
DISASSEMBLY
WARNING
Wear suitable eye protection during removal of snap rings. Failure to follow this warning may
cause injury.
CAUTION
Do not clamp weaker center section of driveshaft. Avoid excessive force when holding
driveshaft in a vice. If shaft or yoke is bent, the driveshaft may vibrate when returned to
service.
NOTE
Procedure is same for both driveshafts.
Scribe marks on yoke and universal joints prior to removal to assure proper assembly
and driveshaft balancing.
1.
Remove eight bolts (Figure 1, Item 7) and lockwashers (Figure 1, Item 6) from universal yoke
(Figure 1, Item 3).
2.
With assistance, remove driveshaft (Figure 1, Item 9) and universal yoke (Figure 1, Item 3) as an assembly
from roller.
NOTE
Place driveshaft in vice.
3.
Remove four snap rings (Figure 1, Item 4) from bearing (Figure 1, Item 5) and remove universal yoke
(Figure 1, Item 3).
4.
Remove four snap rings (Figure 1, Item 2), bearings (Figure 1, Item 1), and two universal joints
(Figure 1, Item 8) from driveshaft (Figure 1, Item 9).
5.
Remove dust cap (Figure 1, Item 10) and preformed packing (Figure 1, Item 11), and separate driveshaft
(Figure 1, Item 9). Discard preformed packing.
6.
If damaged, remove plug (Figure1, Item 12).
0215-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00153)