TM 5-3895-379-23-1
0198
INSPECTION AND TESTING
Wiring and electrical inspection and repair is presented in General Wiring Repair (WP 0195). Electrical testing is
presented in Electrical General Maintenance Instructions (Volume 2, WP 0280).
END OF TASK
REMOVAL
NOTE
Remove cable ties as required.
Tag and mark all wires prior to removal.
Tag and mark general position of wiring harness in chassis as components are removed.
Harness will need to be repositioned at start of installation.
1.
Remove nut (Figure 1, Item 6), washer (Figure 1, Item 5), and two wires (Figure 1, Item 4) from frame assembly
(Figure 1, Item 3).
2.
Disconnect rear wire harness connector (Figure 1, Item 2) from connector (Figure 1, Item 1).
1
2
6
5
4
3
M0306SWR
Figure 1. Rear Wiring Harness Removal.
3.
Remove nut (Figure 2, Item 7), washer (Figure 2, Item 6), clip (Figure 2, Item 5), washer (Figure 2, Item 3),
and screw (Figure 2, Item 2) from clip assembly (Figure 2, Item 1).
4.
Remove clip (Figure 2, Item 5) from rear wiring harness (Figure 2, Item 4).
03/15/2011Rel(1.8)root(maintwp)wpno(M00136)