TM 5-3895-379-23-1
0115
FUEL LINES AND FITTINGS INSTALLATION
1.
Install hose (Figure 2, Item 18), connector (Figure 2, Item 17), new O-ring (Figure 2, Item 6), and new seal
(Figure 2, Item 16) on fuel pump (Figure 2, Item 27).
2.
Install hose (Figure 2, Item 18), connector (Figure 2, Item 17), new O-ring (Figure 2, Item 6), and new seal
(Figure 2, Item 16) to fuel/water separator (Figure 2, Item 15).
3.
Install new O-ring (Figure 2, Item 14), adapter (Figure 2, Item 13), new seal (Figure 2, Item 12), elbow
(Figure 2, Item 11), new O-ring (Figure 2, Item 10), connector (Figure 2, Item 9), valve (Figure 2, Item 8),
adapter (Figure 2, Item 7), and new O-ring (Figure 2, Item 6) to hose (Figure 2, Item 2).
4.
Connect adapter (Figure 2, Item 13) to fuel/water separator (Figure 2, Item 15).
5.
Install connector (Figure 2, Item 26), two new O-rings (Figure 2, Item 6), valve (Figure 2, Item 8), adapter
(Figure 2, Item 7), and two loop clamps (Figure 2, Item 25) on hose (Figure 2, Item 28).
6.
Install hose (Figure 2, Item 21), connector (Figure 2, Item 22), and new O-ring (Figure 2, Item 6) on fuel/water
separator (Figure 2, Item 15).
7.
Connect hose (Figure 2, Item 21) to adapter (Figure 2, Item 7).
8.
Install two adapters (Figure 2, Item 30) on fuel tank (Figure 2, Item 1).
9.
Install two new O-rings (Figure 2, Item 6) to adapters (Figure 2, Item 29).
10.
Connect hose (Figure 2, Item 2) and hose (Figure 2, Item 28) to two adapters (Figure 2, Item 29).
11.
Install two bolts (Figure 2, Item 19), six washers (Figure 2, Item 20), and two nuts (Figure 2, Item 24) to two
loop clamps (Figure 2, Item 25).
12.
Install three bolts (Figure 2, Item 5), three plates (Figure 2, Item 4), and six block clamps (Figure 2, Item 3).
13.
Turn two fuel shut-off valves (Figure 2, Item 8) to ON position (WP 0124).
0115-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00053)