TM 5-3895-379-23-1
0078
REMOVAL - Continued
27.
Disconnect wiring harness (Figure 19, Item 1) from hydraulic oil temperature switch (Figure 19, Item 2). Move
harness aside.
28.
Remove two bolts (Figure 19, Item 3), washers (Figure 19, Item 4), and starter relay (Figure 19, Item 5) from
frame.
29.
Cut cable ties securing starter relay (Figure 19, Item 5) and wiring harness (Figure 19, Item 6). Move harness
aside.
3, 4, 5
1, 2
6
M0023SWR
Figure 19. Engine Assembly Removal.
30.
Remove bolt (Figure 20, Item 3) and three screws (Figure 20, Item 2) securing electrical connector
(Figure 20, Item 1) to frame.
31.
Separate electrical connector (Figure 20, Item 1), by disconnecting connector halves.
32.
Disconnect electrical connector (Figure 20, Item 4).
33.
Remove nut (Figure 20, Item 5) and washer (Figure 20, Item 6) securing ground wire (Figure 20, Item 7) to
frame.
03/15/2011Rel(1.8)root(maintwp)wpno(M00017)
