TM 5-3895-379-10
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
ROLLING PROCEDURES - CONTINUED
NOTE
Turn vibration system off before stopping on hot asphalt.
Roll with Lead Drum Static and Trailing Drum Vibrating. Running with the lead drum static and the trailing drum
4.
vibrating is not recommended since the static drum will tend to push the material.
PARK ROLLER
NOTE
1
CB534B and CB534C Rollers are parked
the same way. CB534B Roller is shown.
1.
Move roller to secure area on level ground.
2
2.
Turn off vibratory system. Refer to Operate Vibratory
System in this work package.
3.
Move propel control lever (1) to the center position to
stop roller.
NOTE
Parking brake switch will be illuminated
while parking brake is engaged and engine
start switch is in ON position.
4.
Press parking brake switch (2) to engage parking
401-046
brake.
NOTE
Drain the water tanks at the end of each work day to prevent freezing and biological growth from occurring
during periods of roller inactivity.
5.
Turn off water spray system. Refer to Operate Water Spray System in this work package.
6.
Shut down engine. Refer to Operate Engine in this work package.
7.
Dismount roller. Refer to Mounting and Dismounting Roller in this work package.
NOTE
Battery disconnect switch should be turned off at the end of each work day.
8.
Ensure that battery disconnect switch is turned off and key is removed. Refer to Operate Engine in this work package.
0005 00-18
