SECTION 7
TRANSMISSION
g. Install two alignment bolts and spline the planetary
NOTE: The frame-motor housing capscrews will turn
anchor flange on to the outer planetary hub (C350B
hard as the drum is being pulled into position by
only) (see figure 7-95). Install two capscrews in two
these cap- screws. Torque the capscrews per
remaining holes and torque to 120 ft.lbs. (C350B only)
specification. Install the drive shaft.
(16.6 kg-m).
d. Install snap ring on brake shaft (C350B only) (see
NOTE: The alignment mark on the anchor flange should
be aligned to the alignment mark on the
e. Turn the drive shaft from the motor housing end
planetary hub (C350B only).
until the oil holes in the outer planetary hub are
horizontal with the floor and above center (C350B only)
h. Insert three equally spaced capscrews. Torque
(see figure 7-94).
these capscrews to 15 ft.-lbs. (2.074 kg-m) and then
remove them (see figure 7-96).
f. Install scraper bar and bumper assembly if removed
during disassembly.
FIGURE 7-95.
FIGURE 7-93.
FIGURE 7-94.
FIGURE 7-96.
7-49.