SECTION 7
TRANSMISSION
distance between the motor housing hub and the
NOTE: Rotate the bearing carrier on the motor housing
straight edge (see figure 7-86).
hub to insure proper seating of the bearing and
the oil seal lip.
h. Assemble a shimpack equaling measurement
determined in step g plus .001 in. (.025 mm). Replace
f. Temporarily install the bearing retainer plate and
the bearing retainer plate and torque capscrews to 105
torque the capscrews to 25 ft.-lbs. (3.457 kg-m). Rotate
ft.-lbs. (14.521 kg-m) (see figure 7-87).
the bearing retainer on the motor housing hub to insure
proper seating of the bearings (see figure 7-85).
i. Install the o-ring (well lubricated) on the bearing
carrier. Seat against the mounting flange (see figure 7-
g. Remove the bearing retainer plate and place a
88).
straight edge across the end of the motor housing hub
and bearing cone. With a feeler gauge measure the
FIGURE 7-87.
FIGURE 7-85.
FIGURE 7-88.
FIGURE 7-86.
.
7-47.