TM 5-3895-346-14
HYDROSTATIC SYSTEM
PUMP REPAIR
Figure 13.
If the cylinder block assembly does not remain together during removal, it can be easily reassembled at a later
time (refer to Fig. 14).
Figure 14.
Figure 15.
Set the pump on the servo housings and remove the front cover screws (refer to Fig. 15).
Figure 16.
Figure 17.
Lift off the front cover and gasket (refer to Fig. 16).
The race for the tapered shaft bearing is a press fit
in the front cover (refer to Fig. 17).
Lift the shaft and bearing out of the center hole of
the swashplate (refer to Fig. 18).
Figure 18.
540