TM 5-3895-383-24
Circuit Breakers - Reset
SMCS Code: 1420-529
Illustration 140
The circuit breakers are located on the right side of the
operator console. In order to remove the cover (1), remove the
four screws. There is one screw at each corner of the cover.
After all of the repairs are completed, place the cover over the
circuit breakers. Install the four screws.
Circuit Breaker/Reset - Push in the button in order to
reset the circuit breaker. If the electrical system is
functioning
properly,
the
button
will
remain
depressed. If the button does not remain depressed,
check the appropriate electrical circuit. Repair the electrical
circuit, if necessary.
Illustration 141
(2)
This circuit breaker is designed to protect the electronic
throttle. The circuit breaker has a capacity of 15 Amp.
(3)
This circuit breaker is designed to protect the alternator.
For example, if the batteries are installed with reversed
polarity, the circuit breaker would prevent the alternator
from damaging the rectifier. The circuit breaker has a
capacity of 60 Amp.
Maintenance Section
Circuit Breakers - Reset
1-67
