TM 5-3895-383-24
Backup Alarm - Test
SMCS Code: 7406-081
The backup alarm is located at the rear of the machine.
Illustration 132
Turn the engine start switch to the ON position in order to
perform the test.
Apply the parking brake. Move the propel control lever to the
REVERSE position.
The backup alarm should start to sound immediately. The
backup alarm will continue to sound until the transmission
control lever is moved to the STOP position or to the
FORWARD position.
Illustration 133
In order to adjust the volume level, turn the three-position
selector switch. The switch is located on the back of the
backup alarm. When the machine is shipped from the factory,
the three-position selector switch is set to the HIGH setting.
The three-position selector switch should remain at the HIGH
setting unless the job site requires a lower volume level.
Battery - Clean/Check
SMCS Code: 1401-535
Illustration 134
Illustration 135
NOTE:
The batteries that are supplied with the machines
are maintenance free batteries. You do not need
to check the level of the electrolyte in the
maintenance free batteries.
Tighten the battery retainers on both of the batteries. Tighten
the battery retainers at every 1000 hours.
Check the following items at every 1000 hours. If necessary,
check the following items more often.
Clean the top of the batteries with a clean cloth.
Clean the battery terminals. As needed, coat the
battery terminals with petroleum jelly.
Maintenance Section
Backup Alarm - Test
1-64
