TM 5-3895-383-24
(13) Backup ring. (14) O-ring seal. (15) O-ring seat (16) Two
bearing races. (17) Needle thrust bearing. (18) Pin. (19)
Control spool. (20) Control sleeve. (21) Centering spring kit.
17.
Components of the gerotor assembly shown in above
photo.
18.
Remove retaining ring (22) and gland bushing (23) from
the control housing.
19.
Disassemble gland bushing (23). Remove dust seal
(24) from seal gland bushing (25). Turn the seal gland
bushing over and remove quad ring seal (26).
20.
Remove set screw (27) from control housing (12).
21.
Install an 1/8"-24 machine screw into the end of the
check ball seat (28). Remove the check ball seat with
pliers.
NOTICE
O-ring seals (31) and (32) are different sizes. Note their
location on the check ball seat prior to removal. Do not
mix when reinstalled.
14-21
