TM 5-3895-383-24
7.
Remove four bolts (11) and side panel (12).
8.
Disconnect five electrical connectors (13).
9.
Install pin (14) in the pivot point on both sides of the cab
as shown.
10.
Rotate valve (16) clockwise to the raise position.
11.
Inset handle (17) into pump (15). Move the handle
upward and downward to raise the cab.
12.
Raise cab (18) as shown.
13.
Install two pins (19) to hold cab in the tilted position as
shown.
NOTE:
To lower the cab, reverse the tilt steps.
End By:
a.
close engine enclosure
14-12
