TM 5-3895-383-24
(6)
Valve push rod length:
Type III (Floating Button Rocker
Arm)............................................................235 mm (9.25 in)
NOTE:
Valve push rod length (6) corresponds to an
overall length measurement (top of cup to bottom
of ball) as taken by a serviceman with a scale.
The valve push rod length (6) is intended to
provide a means of identification.
(7)
Bore in lifter arm for shaft
(new) ......................................................15.670 ± 0.012 mm
(.6169 ± .0005 in)
Diameter of shaft (new).......................15.620 0.012 mm
(.6150 .0005 in)
Torque for bolts holding lifter shaft to the side
cover.......................................... 13 ± 3 N m (9.6 ± 2.2 lb-ft)
Valve Cover
3114 Valve Cover Tightening Sequence
3116 & 3126 Valve Cover Tightening Sequence
Bond gasket to valve cover using 8T9021 Depend No-Mix
Adhesive midway between each bolt hole.
Tighten valve cover bolts in sequence shown to a torque of12 ± 3 N m (106 ± 27 lb-in)
Cylinder Head
3114 Cylinder Head Tightening Sequence
3116 & 3126 Cylinder Head Tightening Sequence
(1)
Large bolts (M20).
(2)
Small bolts (M10).
Instructions for installing bolts (1) and (2): Put clean
engine oil, 4C5593 Thread Lubricant, or 6V4876
Molykote Paste Lubricant on the threads of the bolts
and tighten them as follows:
a.
Tighten large bolts in number sequence shown to a
torque of...........................................................150 ± 15 N m
(110 ± 11 lb-ft)
b.
Tighten large bolts in number sequence shown to a
torque of...........................................................435 ± 20 N m
(320 ± 15 lb-ft)
c.
Retorque large bolts in number sequence shown to435 ±
20 Nm ...........................................................(320 ± 15 lb-ft)
d.
Tighten small bolts in number sequence shown to a
torque of...............................................................55 ± 7 N m
(41 ± 5 lb-ft)
5-13
