TM 5-3895-383-24
(3)
Depth that all cup plugs are installed (measured from
head face to top edge of plug)
............................................1.25 ± 0.25 mm (.049 ± .010 in)
Use 6V1541 Quick Cure Primer and 9S3265 Retaining
Compound in the plug bores at assembly.
Cylinder Head Cross Section
(4)
Sleeve. For replacement of a unit injector sleeve, refer
to Using The 122-7093 Sleeve Replacement Tool
Group, Special Instruction SEHS9120.
(5)
Thickness of cylinder head:
New ............................103.00 ± 0.20 mm (4.055 ± .008 in)
Minimum permissible thickness ....................... 102.55 mm
(4.037 in)
Camshaft
TYPE I
(1)
Gear. Heat to install (do not use a torch). Do not
heat above......................................................316C (600F)
(2)
Distance between shoulder of camshaft and gear
for thrust washer (new) ..............................4.83 ± 0.05 mm
(.190 ± .002 in)
Thickness of thrust washer (new).............4.65 ± 0.03 mm
(.183 ± .001 in)
End play of the camshaft (new) ................0.18 ± 0.08 mm
(.007 ± .003 in)
Maximum permissible end play
(worn) ........................................................0.64 mm (.025 in)
(3)
Diameter of camshaft journals
(new) ................... 65.126 ± 0.013 mm (2.5640 ± .0005 in)
(4)
Intake lobe.
(5)
Injector lobe.
(6)
Exhaust lobe.
TYPE II
(1)
Gear. Heat to install (do not use a torch). Do not heat
above...............................................................316C (600F)
(2)
Distance between shoulder of camshaft and gear for
thrust washer (new) ....................................4.83 ± 0.05 mm
(.190 .002 in)
Thickness of thrust washer (new)...........................4.7 mm
(.185 in)
End play of the camshaft (new) ................0.13 ± 0.05 mm
........................................................................ (.005 ± .002 in)
Maximum permissible end play (worn) ................0.64 mm
(.025 in)
(3)
Diameter of camshaft journals
(new) ................... 65.126 ± 0.013 mm (2.5640 ± .0005 in)
(4)
Intake lobe.
(5)
Injector lobe.
(6)
Exhaust lobe.
Typical Example
5-14
