TM 5-3895-382-24
8.
Repeat Steps 1 through 7 for the remaining main
bearings.
9.
Rotate the crankshaft in order to ensure that the
crankshaft turns freely.
Illustration 210
Typical example.
10.
Check the crankshaft end play. Use a prybar to move
the crankshaft toward the rear of the engine. Install
Tool (B) and zero the dial indicator. Move the
crankshaft with the prybar toward the front of the
engine. Measure the crankshaft end play. The
maximum permissible crankshaft end play is 0.51 mm
(.020 inch).
NOTE:
If the crankshaft was not removed for the rear
main bearing removal, the following components
must be installed: bridge assembly, rear oil seal
housing, flywheel housing and flywheel.
End By:
a.
Install the engine oil relief valve and the strainer
assembly. Refer to Disassembly and Assembly,
"Engine Oil Relief Valve - Remove and Install".
Crankshaft - Remove
SMCS Code: 1202-011
Removal Procedure
Start By:
a.
Remove the fuel injection pump. Refer to
Disassembly and Assembly, "Fuel Injection Pump -
Remove".
b.
Remove the engine oil pump. Refer to Disassembly
and Assembly, "Engine Oil Pump - Remove".
c.
Remove the front housing. Refer to Disassembly and
Assembly, "Housing (Front) - Remove".
d.
Remove the flywheel housing. Refer to Disassembly
and Assembly, "Flywheel Housing - Remove and
Install".
e.
Remove the housing for the crankshaft rear seal.
Refer to Disassembly and Assembly, "Crankshaft
Rear Seal - Remove".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 211
1.
Remove two socket head bolts (1).
2.
Remove bridge (2).
Illustration 212
7-83
