TM 5-3895-382-24
(2)
The maximum temperature for heating the flywheel ring
gear for installation .....................................250 C (482 F)
(3)
Tighten flywheel bolts to the following
torque: ......................................................105 Nm (77 lb-ft)
Flywheel Housing Runout
Face Runout
Illustration 52
Face Runout Check
Maximum permissible face runout of the flywheel
housing .............................................................0.20 mm (.008 inch)
Refer to Testing and Adjusting, "Flywheel and Flywheel
Housing" for the correct procedure to measure the runout.
Bore Runout
Illustration 53
Bore Runout Check
Maximum permissible bore runout of the flywheel
housing ............................................................0.20 mm (.008 inch)
Refer to Testing and Adjusting, “Flywheel and Flywheel
Housing” for the correct procedure to measure the runout.
Flywheel Runout
Face Runout
Illustration 54
Face Runout Check
5-38
