TM 5-3895-382-24
Housing (Front)
SMCS Code: 1151
Illustration 48
Timing Case And Cover
(1)
Timing case
Tighten the bolts (not shown) for the timing case to the cylinder
block to the following torques:
M8 (not shown)..........................................22 Nm (16 lb-ft)
M10 (not shown)........................................44 Nm (32 lb-ft)
Tighten the bolts and the nuts for the cover of the timing case
to the following torques:
(2)
M8 bolts ......................................................22 Nm (16 lb-ft)
(3)
M8 nuts (not shown) for bolts..................22 Nm (16 lb-ft)
(4)
Oil seal housing
Illustration 49
Oil Seal Housing
(5)
Tighten the bolts for the oil seal housing (3) to the
following torque: .......................................22 Nm (16 lb-ft)
Gear Group (Front)
SMCS Code: 1206
Illustration 50
(1)
Fuel pump drive gear:
Bore ..................36.00 to 36.06 mm (1.417 to 1.420 inch)
Tighten the four bolts to the
following torque: .......................................28 Nm (21 lb-ft)
Tighten the two torque screws to the
following torque: ........................................... 9 Nm (7 lb-ft)
NOTE: The torque screws retain the timing plate on the
front of the gear. This plate is installed in the
factory after the fuel injection timing has been
accurately set to the top center position on the
compression stroke of number 1 cylinder. If the
timing plate is moved, the timing of the fuel
injection pump must be set.
5-36
