(9)
Install indicator (37) on arm (35).
(10)
Install four sleeve bearings (47) on arm (35).
(11)
Install spacer (46), spacer (45), and spacer (44)
on arm (35).
(12)
Install bur roller guides (43) on arm (35).
(13)
Slide indicator (37) into spring pin (38) while
installing arm (35) in lower housing assembly
(28).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give
off harmful vapors, and are harmful
to skin and Clothing. To avoid injury
or death, keep away from open fire
and use in a well-ventilated area. If
adhesive,
solvent,
or
sealing
compound gets on skin or Clothing,
wash immediately with soap and
water.
(14)
Apply sealant to threads of four bolts (40).
(15)
Install left hand angle (41) and right hand angle (42) on lower housing assembly (28) with four bolts (40) and
locknuts (39). Tighten nuts to 7.4 to 16.2 lb-ft (10 - 22 Nm).
(16)
Install shaft (26) in lower housing assembly (28) and arm (35) with retainer (27).
(17)
Install spring (36) in lower housing assembly (28) by compressing and turning spring to right until spring is
securely seated in all three tabs.
2-66
