TM 5-3895-382-24
b. Assembly
NOTE
Plate assembly should be positioned
at least halfway down threads of gear
assembly.
(1)
Install plate assembly (58), spacer (57), and
groove pin (56) on gear assembly (29).
(2)
Install spring pin (38) in lower housing assembly
(28) allowing pin to protrude from front of lower
housing assembly.
(3)
Install two bumper assemblies (55) in lower
housing assembly (28).
(4)
Install two roller pads (54) in lower housing
assembly (30).
(5)
Install two sleeve bearings (53) in shock
absorber (52).
(6)
Install shock absorber (52) on lower housing
assembly (28) with bolt (51), and locknut (50).
Tighten locknut to 7.4 to 16.2 lb-ft (10 - 22 Nm).
(7)
Install two bumper assemblies (49) in upper
housing assembly (21).
(8)
Install two roller pads (48) in upper housing
assembly (21).
2-65
TM 5-3895-382-24
