TM 5-3895-379-23
STEERING CONTROL UNIT (SCU) REPAIR - CONTINUED
0195 00
ASSEMBLY - CONTINUED
NOTE
The steering control unit (SCU) must be timed, this requires the correct relationship between pin, gero-
tor and housing. One end of pin will point to the largest clearance between the gerotor and gerotor hous-
ing. The other end of the pin points to the least clearance.
Pin cannot be seen after drive is installed, so it will be necessary to make a mark on the gear end of the
drive for proper alignment.
Be sure the bolt holes in the spacer plate align with the tapped holes in the center housing.
14.
Install spacer plate (21).
19
NOTE
18
Be sure the slot in drive (20) engages with
21
pin (31).
15.
Install drive (20) and spacer (19) in geroter (18).
20
401-1123
16.
Install new seal (17) in geroter housing (16).
17
16
401-1122
17.
Position geroter housing (16) on steering control unit.
16
401-1121
0195 00-11
