TM 5-3895-379-23
STEERING CONTROL UNIT (SCU) REPAIR - CONTINUED
0195 00
ASSEMBLY - CONTINUED
4.
Install the check ball seat (40) in center of control housing (35), using an 1/8 in.-24 machine screw.
NOTE
After installation, the set screw should be slightly below the outside surface of the center housing.
5.
Install setscrew (39) in control housing (35) and tighten to 8 lb-in (11 Nm).
40
39
35
35
401-1135
401-1136
6.
Assemble gland bushing (34). Install new dust seal (36) in seal gland bushing (37) with the flat or smooth side of seal
facing bushing and turn seal gland bushing over. Install new quad ring seal (38) in the seal gland bushing. Smooth seal
in place with finger.
7.
Install gland bushing assembly (34) in control housing (35) and secure with new retaining ring (33).
35
37
38
36
34
33
401-1132
401-1133
0195 00-8
