TM 5-3895-379-23
WATER SPRAY PIPE ASSEMBLY MAINTENANCE - CONTINUED
0152 00
DISASSEMBLY
1.
Remove cap (16) from clamp (17) by turning coun-
terclockwise.
21
2.
Remove screen (18), seal (19) and nozzle (20) from
cap (16).
17
3.
Remove two screws (21) and clamp (17) from water
10
spray pipe assembly (15).
17
4.
Repeat steps 1 through 3 for remaining clamps as
required.
19
5.
Remove two elbows (10) from water spray pipe
assembly (15).
16
15
18
20
401-767
CLEANING AND INSPECTION
1.
Clean screen, seal, nozzle and clamp with detergent and water. Remove difficult deposits with a stiff bristle brush.
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Failure to follow this warning may cause injury or death. Make
sure stream is directed away from user and other personnel in the area. To prevent injury, user must wear
protective goggles or face shield.
2.
Use a cleaning cloth or compressed air to dry metal parts.
3.
Check cap and clamp for cracks and wear on locking parts.
4.
Check screen for crushing, corrosion or tears.
5.
6.
Check nozzle for clogging, corrosion or excessive wear.
7.
Replace all damaged parts.
0152 00-3