TM 5-3895-379-23
WATER SPRAY STRAINER ASSEMBLY MAINTENANCE - CONTINUED
0149 00
CLEANING AND INSPECTION
1.
Clean strainer assembly bowl and screen with non-sudsing detergent and water. Remove difficult deposits with a clean-
ing brush.
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Failure to follow this warning may cause injury or death. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user must wear
protective goggles or face shield.
2.
Use cleaning cloth or compressed air to dry metal parts.
3.
Check bowl for cracking, corrosion or excessive wear.
4.
Check screen for clogging, corrosion, excessive wear and obvious signs of damage.
5.
Check all parts for stripped or damaged threads.
6.
Replace all damaged parts.
ASSEMBLY
1.
Install screen (4) and seal (5) on strainer assembly bowl (2).
2.
Install strainer assembly bowl (2) in strainer assembly (3).
3.
Turn valve handle (1) to the open position. (CB534B Roller).
4.
Start engine, operate water spray system and check for leaks (TM 5-3895-379-10).
5.
Remove chocks (TM 5-3895-379-10).
END OF WORK PACKAGE
0149 00-3/(0149 00-4 Blank)
