TM 5-3895-379-23
PROPEL CONTROL LEVER ASSEMBLY MAINTENANCE - CONTINUED
0113 00
DISASSEMBLY
1.
Remove retainer ring (15) and boot (16) from handle (17).
CAUTION
Do not turn handle more than one full turn. Handle cannot be removed by unscrewing and should not be
forced or turned more than needed to allow access to screws and nuts. Forcing the handle to turn further will
damage the handle.
2.
Loosen handle (17) on handle pipe (18) by turning handle (17) counterclockwise not more than 1 full turn.
NOTE
Use care to not lose nuts during removal. Nuts are small and may stay with handle.
3.
Remove two screws (19), four screws (20) and six nuts (21) from two handles (17).
4.
Remove two handles (17) from handle pipe (18).
5.
Remove two gaskets (22) from handles (17). Discard gaskets.
6.
Remove nut (23) and preformed packing (24) from handle pipe (18). Discard preformed packing.
NOTE
Note that cams are different lengths.
7.
Raise boot (25) and remove two screws (26) and cam (27).
8.
Remove two retaining rings (28), pivot pin (29) and two cams (30).
9.
Remove two screws (31) and wires (32) from vibration push switch (33).
10.
Loosen nut (34) and remove handle pipe (18).
11.
Remove nut (34), adjuster (35), boot (25) and boot sleeve (36).
NOTE
Note position of washers to aid in installation.
Count number of turns necessary to remove pivot plate from pivot bolt.
12.
Remove outer bracket (37), three washers (38), two wires (32) and bronze wear shoe (39) from pivot bolt (40).
13.
Remove pivot plate (41) from pivot bolt (40).
14.
Remove three screws (42) and switch (43) from pivot bracket (44).
0113 00-4