TM 5-3895-379-23
PROPEL CONTROL LEVER ASSEMBLY MAINTENANCE - CONTINUED
0113 00
ASSEMBLY
1.
Install switch (43) and three screws (42) on pivot bracket (44).
2.
Install pivot bolt (40) on pivot plate (41) using same number of turns noted during removal.
NOTE
Install washers as noted in removal.
3.
Install outer bracket (37), three washers (38), two wires (32) and bronze wear shoe (39) to pivot bolt (40).
4.
Install adjuster (35), boot (25) and boot sleeve (36).
5.
Install, but do not tighten nut (34). Install handle pipe (18) and tighten nut (34).
6.
Install two screws (31) and wires (32) on vibration push switch (33).
7.
Install two retaining rings (28), pivot pin (29) and two cams (30).
8.
Lower boot (25) and install two screws (26) and cam (27).
9.
Install nut (23) and new preformed packing (24) to handle pipe (18).
10.
Install two new gaskets (22) to handles (17).
11.
Install two handles (17) to handle pipe (18).
NOTE
Grip housings will not fit together if any threads of handle pipe are showing on top side of nut while nut
is installed.
Mate flat sides of nut with cavity on grip housing.
Use care not to lose nuts during installation. Nuts are small and easily lost.
12.
Install two screws (19), four screws (20) and six nuts (21) to two handles (17).
CAUTION
Do not turn handle more than one full turn. Handle should not be forced or turned more than needed to
tighten. Forcing the handle to turn further will damage the handle.
13.
Tighten handle (17) on handle pipe (18) by turning grip housings clockwise not more than one full turn.
14.
Install retainer ring (15) and boot (16) to handle (17).
0113 00-6