TM 5-3895-379-23
VIBRATION SENSOR MAINTENANCE - CONTINUED
0097 00
REMOVAL
NOTE
Right- and left-front vibration sensors are maintained the same way. Right-front sensor is shown.
Vibration sensors are located on left-side of rear drum and right-side of front drum.
1.
Disconnect connector (1) from vibratory sensor connector (2).
WARNING
Oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause injury.
NOTE
Use container to catch any hydraulic oil that may drain from hose assembly. Dispose of oil IAW local policy
and ordinances.
2.
Place container with 2 qt (1.9 l) minimum capacity under hose assembly (3).
3.
Disconnect hose assembly (3) from elbow (4) and allow hydraulic fluid to drain into container.
4.
Loosen nut (5) and remove vibration sensor (6) and spacer (7) from plate (8).
8
1
7
6
2
5
3
4
401-510
0097 00-2