TM 5-3895-379-23
ENGINE BLOCK HEATING ELEMENT REPLACEMENT- CONTINUED
0044 00
REMOVAL - CONTINUED
7.
Remove three nuts (11), washers (12), clips (13),
screws (14) and washers (12) from frame assembly
(15).
8.
Slide boot (16) on cable (2) back to expose two lock-
nuts (17).
9.
Remove two locknuts (17), receptacle (18), two
screws (19), receptacle cover (20) and seal (21) from
bracket (22). Discard locknuts.
INSTALLATION
1.
Install seal (21), receptacle cover (20), two screws
(19), receptacle (18) and two new locknuts (17) on
bracket (22).
2.
Slide boot (16) on cable (2) to cover two locknuts
(17).
3.
Install cable (2) into three clips (13).
14
15
4.
Install three washers (12), screws (14), clips (13),
washers (12) and nuts (11) to frame assembly (15).
12
5.
Install drain plug (8) into engine block fitting (9).
6.
If removed, install engine block fitting (9) into engine
block (10).
16
7.
Install engine block heating element (6) into engine
block fitting (9).
2
17
12
13
18
22
11
21
19
20
401-390
8.
Install wire (7) to engine block heating element (6) and tighten screw (4).
9.
Install two wires (5) and screws (3) to engine block heating element (6).
10.
Slide boot (1) on cable (2) to cover three screws (3 and 4).
11.
Fill engine with coolant (WP 0008 00 and WP 0009 00).
12.
Install air cleaner cap (WP 0031 00).
13.
Lower operator platform assembly (WP 0128 00).
14.
Close left-side door assembly (TM 5-3895-379-10).
15.
Start engine and check for leaks (TM 5-3895-379-10).
END OF WORK PACKAGE
0044 00-3/(0044 00-4 Blank)
