TM 5-3895-379-23-2
0235
LOWER PLATFORM
1.
Remove two locknuts (Figure 4, Item 4), washers (Figure 4, Item 6), and screws (Figure 4, Item 7) from frame
assembly (Figure 4, Item 5) and operator platform assembly (Figure 4, Item 3).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
CAUTION
Operate wire rope hoists evenly to decrease chance of equipment failure.
2.
With assistance, use wire rope hoists (Figure 4, Item 8) to lower operator platform assembly
(Figure 4, Item 3) until platform rests on frame assembly (Figure 4, Item 5).
3.
Remove wire rope hoists (Figure 4, Item 8) from each chain and eyelets in handrail assemblies
(Figure 4, Items 1 and 2).
4.
Remove short section of chain (Figure 4, Item 10) from cutout in each front side of yoke assembly
(Figure 4, Item 9).
5.
Install two screws (Figure 4, Item 7), washers (Figure 4, Item 6), and locknuts (Figure 4, Item 4) in storage
locations in frame assembly (Figure 4, Item 5). Tighten locknuts to 48-55 lb-ft (65-75 Nm).
2
3
1
4
3
5
6
7
8
10
9
M0745SWR
Figure 4. Lower Operator Platform Assembly.
03/15/2011Rel(1.8)root(maintwp)wpno(M00173)
