TM 5-3895-379-23-1
0080
INSTALLATION
1.
Install front engine mount (Figure 4, Item 11) on engine (Figure 4, Item 8) with four washers (Figure 4, Item 9)
and screws (Figure 4, Item 10). Tighten screws to 145-205 lb-ft (197-278 Nm).
WARNING
Do not place fingers between engine mount and frame assembly. Shifting engine may cause
injury.
2.
Position two resilient mounts (Figure 4, Item 3) between front engine mount (Figure 4, Item 11) and frame
assembly (Figure 4, Item 4).
3.
Install two spacer sleeves (Figure 4, Item 7), washers (Figure 4, Item 2), bolts (Figure 4, Item 1), washers
(Figure 4, Item 5), and nuts (Figure 4, Item 6) in front engine mount (Figure 4, Item 11) and frame assembly
(Figure 4, Item 4). DO NOT tighten nuts.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
Engine weighs 2,000 lb (907 kg).
4.
With assistance, use a lifting device to lower engine (Figure 4, Item 8).
5.
Tighten nuts (Figure 4, Item 6) to 145-205 lb-ft (197-278 Nm).
0080-6
03/15/2011Rel(1.8)root(maintwp)wpno(M00019)