TM 5-3895-379-23-1
0048
MALFUNCTION
Brake Control Valve Faulty.
CORRECTIVE ACTION
1.
Disconnect harness connector from brake control connector.
2.
Set multimeter to measure VDC.
3.
Touch positive (+) probe of multimeter to pin 1 (wire 751-GN).
4.
Touch negative (-) probe of multimeter to good ground.
5.
Turn engine start switch to OFF position (TM 5-3895-379-10).
6.
Turn battery disconnect switch to OFF position (TM 5-3895-379-10).
a.
If 24 to 28 VDC are measured at wire 751-GN, replace brake control valve (WP 0216).
b.
If 24 to 28 VDC are not measured at wire 751-GN, close left-side door assembly
(TM 5-3895-379-10) and go to next malfunction.
WIRE 200-BK
SHIFT SOLENOID
PIN 2
SHIFT
CONNECTOR
WIRE
751-GN
PIN 1
T0127SWR
Figure 2.
Shift Solenoid Wiring.