TM 5-3895-379-23-1
0034
TROUBLESHOOTING PROCEDURE
WARNING
Remove all jewelry such as rings, dog tags and bracelets. If jewelry contacts electrical
connection, a direct short may occur resulting in injury or death and damage to equipment.
SYMPTOM
STARTING AID SWITCH DOES NOT WORK
MALFUNCTION
No Power At Starting Aid Switch.
CORRECTIVE ACTION
1.
Remove two shoulder screws, washers, and vandal guard from box assembly.
2.
Remove three screws and washers and lift box assembly up from operator station.
3.
Turn battery disconnect switch and engine start switch to ON position (TM 5-3895-379-10).
4.
Touch positive (+) probe of multimeter to terminal 2 (wire 148-WH).
5.
Touch negative (-) probe of multimeter to good ground.
If 24-28 VDC are not measured at terminal 2 and START AID fuse is good, perform the
following:
(1)
Turn engine start switch to OFF position (TM 5-3895-379-10).
(2)
Turn battery disconnect switch to OFF position (TM 5-3895-379-10).
(3)
Repair or replace wiring and connectors to starting aid switch (WP 0195).
0034-2
03/15/2011Rel(1.8)root(tswp)wpno(T00040)
