TM 5-3895-379-10
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
PREPARATION FOR TRANSPORT - CONTINUED
WARNING
Lifting equipment used for lifting roller must be in good condition and of suitable load capacity. Failure
to follow this warning may result in injury, death or damage to roller.
Improper use of lifting equipment and improper attachment to roller can result in injury or equipment
damage. Observe all standard rules of safety.
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
CB534B Roller weighs 21,232 lb (9631 kg).
CB534C Roller weighs 21,832 lb (9903 kg).
Lifting eyes are identified by a label that shows a hook and/or the stencil "LIFT HERE".
d.
Attach crane or other suitable lifting device to front and rear lifting eyes (5) on both sides of roller.
e.
Lift roller slowly to ensure roller stays level.
f.
Position roller on shipping bed of transport vehicle or railcar.
CAUTION
Blocks are placed to prevent excessive loads on drum support bearings. Failure to chock drums may result in
damage to roller.
g.
When roller is in position, place blocks high in center of yoke on each side of roller in front and rear. Chock drums.
Refer to Chock Drums in this work package.
0005 00-24
