will cause minor adjustment in RPM's If roller is to TRAVEL (not compact), place the Two-Speed Control Lever in ''high
range", located to the right and behind operator High range is for traveling only. If roller is to compact, place the
Two-Speed Control Lever in "low range".
4. For compacting, move the Forward-Reverse Travel Lever (14) up to approximately 2 MPH (The 2 MPH must be
estimated as compared to a "slow walk" since the machine is not equipped with a speedometer The further the lever is
moved forward, away from neutral, the faster the machine will travel )
5 Engage vibrator by moving the Vibration Control Lever (13) forward away from neutral The further this lever is moved
away from neutral, the higher the vibration frequency winch can be read on the Vibration Frequency Gauge (12)
5 To reverse direction - move the Vibration Control Lever (13) back to neutral. Move Forward-Reverse Lever (14) back to
neutral Hydrodynamic braking will occur It is recommended not to use the Brake (15) for repeated stops as the brake is
used for parking or emergency stops only
7 When machine comes to a complete stop, move the Forward-Reverse Lever (14) back reversing direction
Move Vibration Control Lever (13) back reversing rotation of the eccentric shaft within the steel roller. Resume
compaction.
IMPORTANT
Always move the Travel Control Lever and the Vibration Control Lever in the same direction when rolling, either forward
or reverse
With the control levers together, in either direction, the vibrator shaft should always rotate opposite the direction of travel.
If it does not, reverse the high pressure hoses to the vibrator motor. To check the direction of the vibration shaft rotation,
remove the right hand side cover on roll frame and the cap covering the end of vibrator shaft.
B. Shut-Down
1 Return the Vibration Control Lever (13) to neutral and the Forward-Reverse Lever (14) to neutral Return Engine
Throttle (4) to idle by depressing button and pushing down on lever Allow engine to cool at idle for approximately five
minutes Pull out Engine Shut-Down Lever (3) to stop engine Turn Ignition Key (2) to "off".
FIGURE 5
2 Depress Parking Brake (15) Lock Connect steering lock link See figure 5 .
3 When shifting the two speed lever from "low" to ''high'' or vice-versa, bring the machine to a stop and set parking brake
before shifting (Hydrodynamic braking is inoperative when transmission is m neutral ) For ease of shifting jog travel
lever, with engine at low idle, while shifting.
FIGURE 6
ROLL AND TIRE SCRAPERS (Fig 6)
The steel roll is equipped with two rubber scrapers which must be hand adjusted from time to time due to normal wear.
Adjust scraper as required and reverse when worn for double use.
Nylon, spring loaded scrapers are provided for the smooth tires. Lock scrapers back when machine is not used to roll
asphalt surfaces.
10
