SECTION 7
TRANSMISSION
b. Adjust and tighten ball Joint of control cable at
f. Adjust and tighten wire stop at throttle crank for
bail shaft end. Adjust neutral start safety (transmission
1116 In. (1.59 mm) gap between swivel and wire stop
lockout) switch so that it makes contact in neutral.
(see figure 7-44).
c. Move Direction-Throttle Control Bail In the
g. Adjust ball Joint in slotted crank on bail shaft to
forward direction until control cable at servo lever has
allow full throttle when bail Is moved to either full
traveled 11/16 - 31/32 in.(24.64 - 26.92 mm). Adjust bail
forward or full reverse.
stops so that cable cannot be moved beyond this point.
h. Adjust friction control nuts and spring assembly
d. Repeat step c in reverse direction.
so that Direction-Throttle Control Bail will remain in any
desired position.
CAUTION: Ensure that the amount of bail (control
7-173.THROTTLE CONTROL LINKAGE
cable) travel Is limited by ball stops and not the interval
servo stops.
ADJUSTMENT PROCEDURE (see figure 7-44).
e. Return Direction-Throttle Control Ball to neutral
a. Adjust transmission control linkage per
(vertical) position.
procedure outlined in paragraph 7-172 (Sundstrand).
FIGURE 7-44.
7-35.
50.