SECTION 11
WATER SPRAY SYSTEM
c. Remove four (4) mounting plate capscrews and
lower unit to floor.
WARNING: Support mounting plate during capscrew
removal. DO NOT allow subassembly to
fall.
11-16. REPAIR.
11-17. Determine if pump or motor has failed. Separate
pump or motor and replace failed unit. Refer to CHECK
MOTOR BRUSHES paragraph 11-12.
NOTE: The pump impellar is pressed on the armature
shaft.
11-18. INSTALLATION OF PUMP AND MOTOR
ASSEMBLY.
11-19. Install pump and motor assembly by reversing
procedure presented in paragraph 11-15.
11-20. CLEANING THE WATER TANK.
FIGURE 11-4.
a. Drain the water tank for periodic cleaning by
removing the drain plug located under the unit (see
figure 11-5). An access plate Is located at the front of
the unit frame.
FIGURE 11-5.
11-3.