SECTION 9
STEERING
j. Be extremely careful to prevent these parts from
binding as they are very closely fitted and must generally
be rotated slightly as they are withdrawn (see figure 9-20).
k. Using a small bent tool or wire, the check valve
seal can be removed by pushing on it, reaching it through
the "out" port. Do not pry against edge of hole in housing
bore (see figure 9-21).
I. Place housing in vise, control end up, and unscrew
check valve seat with 3/16 inch hex wrench (see figure 9-
22).
m. Up-end the housing and tap slightly with butt of
hand. Hold check valve hole toward lowest corner and
remove check valve seat, ball and spring (see figure 9-23).
FIGURE 9-21.
FIGURE 9-19.
FIGURE 9-22.
FIGURE 9-20.
FIGURE 9-23.
9-8.