SECTION 9
STEERING
a. Place the unit in vise, control end up. Clamp
across port surface and opposite side of housing lightly.
Remove the two capscrews that fasten column to lower
unit. Remove column and set aside. Mark the capscrew
holes so that the ports will be in the proper direction when
reassembled (see figure 9-9).
b. Clamp unit in vise across mounting plate edges
with meter end up and remove 7 capscrews (see figure 9-
10).
c. Lift off metering section (see figures 9-11, 9-12,
and 9-13).
d. Remove control assembly from vise and check for
free rotation of the control spool and sleeve parts with
column shaft (see figure 9-14).
e. Place clean wooden block across vise throat to
support spool parts and clamp unit
FIGURE 9-7.
FIGURE 9-8.
9-5.