OPERATOR AND SERVICE
SECTION 1
INTRODUCTION
MANUAL
frame directly below the nameplate. The serial
GENERAL.
1-1.
number indicates the design series, manufac-
turing plant, serial number and year manufac-
1-2. This publication contains operation and
tured. Example: A91C1501 V.
m a i n t e n a n c e instructions for the C530A
P n e u m a t i c compactor (see figure 1-1). The
SYSTEM SPECIFICATIONS.
1-7.
operating instructions must be carefully
reviewed and understood before attempting to
1-8. Unit specifications for the individual
The
operate the unit,
systems are listed in Section 2.
individual assigned-to operate the unit should
be responsible for maintaining the unit in good
1-9. OPERATING INSTRUCTIONS (see figure
condition to ensure prolonged efficiency.
1-3.
UNIT NAMEPLATE (see figure 1-2).
1 - 1 0 . instructions necessary for safe and
e f f i c i e n t operation are given in Section 3.
1-4. The unit nameplate is located immediately
b e l o w the instrument panel. The nameplate
must remain attached, legible and complete at
all times.
HYSTER-CARE MAINTENANCE.
1-11.
1-5. SERIAL NUMBER DATA (see figure 1-2).
procedures,
1-12. Hyster-Care maintenance
NOTE: The COMPLETE serial number must be
such as servicing intervals, are presented in
identified when ordering parts or
S e c t i o n 4. Always follow the maintenance
c o m m u n i c a t i n g service information to
s c h e d u l e and recommended procedures to
Hyster Company.
ensure prolonged efficiency and service life.
1-6. The unit serial number is located on the
1-13. TROUBLESHOOTING.
unit nameplate. It is also stamped in the unit
FIGURE 1-1.
1-1.