TM 5-3895-346-14
REASSEMBLY
AXLE
2.
Align inner thrust washer hole with planet pinhole so that locating tab of washer lies in spider
indent.
3.
Slide in planet gear and outer thrust washer and align holes.
4.
Press in the planet pin, small diameter end first.
5.
Outer end of pins must be turned so that the machined flat is to the outside of hub circle. This not
only allows cover clearance but also properly locates the planet pin oiling flat.
6.
Proceed in the same manner with the second and third sets of planet pinions and thrust washers.
7.
Planet pins should be pressed through until the shoulder of pin butts thrust washer.
INSTALL SPIDER AND PINION ASSEMBLY
1.
Install spider to hub gasket after making sure that all hub spider studs are properly seated.
2.
Start the spider and pinion assembly, aligning teeth of planet pinions with sun gear and ring gear
teeth.
3.
Align hub studs with spider holes and push spider assembly onto studs against hub gasket.
4.
5.
Tighten nuts to correct torque.
INSTALL COVER
1.
Install new spider to cover gasket against spider. It will be necessary to hold the gasket in place
with a gasket cement so that the gasket hole may be aligned with the spider holes.
2.
Install the spider cover with capscrews and lockwashers. Fill arrow must be in line with hub fill plug
(refer to Fig. 11).
3.
Tighten cover capscrews to correct torque.
LUBRICATION
1.
Turn the complete hub and drum assembly so that the fill plug is at the top (refer to Fig. 11).
Figure 10.
Figure 11.
616