TM 5-3895-346-14
AXLE
REASSEMBLY
On PR models, join spindle to connecting flange with bolts, lockwashers and nuts. Tighten nuts to correct
INSTALL BRAKE ASSEMBLIES
Hydraulic (Refer to Fig. 4.)
1.
Install brake cylinder and push rods.
2.
Install brakeshoe and liner assemblies over anchor pins.
3.
Install anchor pin plate, nut, and cotter key.
4.
Align push rods with shoe webs and hook brakeshoe return spring.
5.
For further detailed information, consult the hydraulic brake section in Field Maintenance manual
No. 4.
ASSEMBLE FLOATING RING GEAR ASSEMBLY
1.
Install splined ring gear hub into the ring gear splines flush with shoulder.
2.
Install the hub to gear connect- ing plates and capscrews.
3.
Tighten capscrews to correct torque.
4.
Lock wire capscrews in sets of two.
5.
Install the outer wheel bearing on ring gear hub journal squarely against hub shoulder. The inner
race of bearing is a slide fit over the spindle hub journal.
ASSEMBLE HUB AND DRUM ASSEMBLY AND INSTALL
If hub bearing cups have been removed for replacement, install new cups with a suitable driving sleeve.
1.
Lift the hub and drum assembly onto the hub
spindle and position so that the inner Cup rests on the inner
bearing rolls.
Figure 3.
Figure 4.
613