TM 5-3895-346-14
AXLE
DISASSEMBLY
REMOVE THE WHEEL HUB AND DRUM ASSEMBLY
1.
Lift the hub and drum slightly to relieve the hub weight and drum to brakeshoe drag and remove
the assembly from the hub spindle (refer to Fig. 12)
2.
If wheel bearings are to be re- placed, remove wheel bearing cups with a suitable puller.
DISASSEMBLE BRAKESHOE AND LINER ASSEMBLY
On planetary axles equipped with hydraulic brakes, the complete disassembly of the brakes is not necessary for
the removal of the hub spindle. Adequate working clearance is provided by only removing the brakeshoe
return spring (refer to Fig. 13).
1.
If the brakeshoe and liner assemblies are to be removed for service or inspection, unhook and
remove the brakeshoe return spring (refer to Fig. 13).
2.
Remove anchor pin plate cotter key, stud nut, and plate (refer to Fig. 14).
3.
Remove the brakeshoe and liner assemblies. For complete disassembly, remove push rods and
brake cylinder.
Figure 12.
Figure 13.
Figure 14.
608
