TM 5-3895-346-14
CYLINDER BLOCK
ENGINE OVERHAUL
4.
Clean and inspect all of the engine parts and subassemblies and, using new parts as required,
install them on the cylinder block by reversing the sequence of disassembly. The procedures for inspecting and
installing the various parts and subassemblies are outlined in the following sections of this manual.
5.
Use a chain hoist and suitable sling to transfer the engine to a dynamometer test stand.
6.
Install the air box covers and tighten the bolts. On in-line engines,tighten the bolts to 12-16 lb ft
(16-22 Nm) torque.
7.
Complete the engine buildup by installing all remaining accessories, fuel lines, electrical
connections, controls, etc.
8.
Operate the engine on a dynamometer, following the run-in procedure outlined in Run-In
Instructions.
9.
Reinstall the engine in the equipment which it powers.
66
