Wipe off the seat cushion covers with a wet cloth. Remove all dust, dirt, and imbedded foreign matter from the seat
cushion springs.
e. Inspection. Inspect the cushions for damaged covers and broken springs. Replace the cushions if excessively
worn or damaged. Check the mounting bolts and nuts for corroded, damaged, or stripped threads. Replace defective
mounting bolts and nuts.
f.
Reassembly (fig. 73).
(1)
Attach the backrest bracket (5) to the backrest cushion (1).
(2)
Install the right (8) and left (11) braces on the backrest cushion (1).
(3)
Install the mounting lockwashers (4) and square nuts (3) and tighten them securely.
(4)
Attach the backrest cushion (1) to the backrest brace (7) and install the plow bolts (6), lockwashers (4),
and nuts (3). Tighten the bolts (6) securely.
(5)
Install the seat base (10) on the seat cushion (9).
(6)
Attach the right (8) and left (11) braces to the seat cushion (9). The braces must be attached to the center
outside studs (2) of the cushion (9).
(7)
Install and tighten the lockwashers (4) and square nuts (3).
g. Installation.
(1)
Install the seat on the seat post. Aline the mounting holes properly.
(2)
Insert the seat post pin.
(3)
Install and secure the cotter pin.
160. Steering Roll Housing Dust Shield
a. General. The steering roll housing dust shield protects the radiator and engine from flying stones, dust, and dirt.
b. Removal.
(1)
Disconnect the sprinkler hose from the steering roll sprinkler system.
(2)
Remove all mounting bolts and lockwashers attaching the dust shield to the frame.
(3)
Remove the dust shield. Due to the weight of the shield, two men will be required for the removal
operation.
c.
Installation.
(1)
See that the sprinkler hose is properly inserted through the dust shield.
(2)
Position the dust shield and see that the mounting holes are properly alined.
(3)
Install and tighten all mounting bolts and lockwashers.
(4)
Connect the sprinkler hose with the steering roll sprinkler and tighten the hose clamp securely.
183
