(2)
Check the doors for breaks, cracks, and damage. Weld minor breaks and cracks. Replace the doors if
badly cracked or warped.
(3)
Check the door locks for corrosion, wear, binding, and sticking. Replace defective or worn door locks.
(4)
Inspect the door hinges for corrosion, etching, twisting, and wear. Make sure that the hinges are swinging
freely on their shafts. Replace damaged or twisted hinges.
(5)
Inspect the gear guard for dents, breaks, cracks, and splitting welds. Weld minor cracks and breaks.
Avoid excessive heat when welding as it may cause the gear guard to warp. Replace the gear guard if
badly broken or warped.
(6)
Check all mounting screws for corroded, worn, damaged, stripped, or galled threads.
Replace all
defective or worn mounting screws and nuts.
(7)
Check the lifting hooks for breaks and cracks. Replace broken, cracked, or twisted lifting hooks.
f.
Reassembly.
(1)
Install the gear-guard hinge (14) on the gear guard (8) and tighten the mounting screws (11), lockwashers
(22), and nuts (3).
(2)
Install the gear guard (8) on the compression roll housing (23) and tighten the mounting screws (7),
lockwashers (6), and plain washers (5).
(3)
Position the door locks (4) in the doors (9) and see that the mounting holes are properly alined.
(4)
Install and tighten the door lock mounting screws (12) and nuts (3).
(5)
Install the door hinges (10) on the doors (9) and tighten the mounting screws (11).
(6)
Install the doors (9) and see that the door locks are properly alined with the door lock latches. Install the
door lock handles (13) on the door locks (4). Turn the door lock handles (13) clockwise until they are
seated securely on their shafts.
(7)
Install the front door hinge (25) on the front door (24) and tighten the mounting screws (11), lockwashers
(22), and nuts (3).
(8)
Position the front door (24) on the compression roll housing (23) and see that the mounting holes in the
housing and door are properly alined.
(9)
Install and tighten the front door mounting screws (11), lockwashers (22), and nuts (3).
(10) Install the identification plate (26) on the compression roll housing (23) and tighten the six drive screws
(27) attaching the identification plate to the housing.
181