TM 5-3895-383-24
7.
Assemble the 126-7187 Adapter (20) into the male end
of the 5R-3796 Quick Coupling Assembly (19). Install
the adapter into the hole for the oil fill/drain plug.
Assemble the 8T-0198 Seal Connector (18) onto the
female end of the quick coupler. Attach the female end
of the quick coupler to the transfer cart suction hose in
order to drain the flushing oil from the housing.
Illustration 190
8.
Rotate the drum until the fill/drain plug is at the bottom.
Put a mark on the surface of the drum at the top of the
drum. The mark will help identify the position of the
fill/drain plug.
Illustration 191
9.
Remove the level check plug. Connect the quick
coupler (19). Fill the housing with 22 L (6 US gal)
gallons of clean oil. Install the plug.
Illustration 192
10.
Run the first flush cycle.
a.
Start the engine. Release the brake.
b.
Set the travel speed control to low speed. In order to
rotate the drum, move the propel control.
c.
Set the vibratory amplitude control to the low position.
Illustration 193
d.
Disconnect the electrical connector to the throttle.
e.
Turn on the vibratory system. Run the vibratory
system for 5 seconds. Turn off the vibratory system.
Repeat the cycle for three minutes.
NOTE:
For each cycle, do not run the vibratory system
more than 5 seconds.
f.
Stop the drum. Position the drum in order to drain the
housings.
11.
Install the transfer cart. Pump the oil out of the
housings. Cycle the oil through the filter for 30 minutes.
Cycle the oil until the oil is cleaned to a rating of ISO
18/13 or better.
Maintenance Section
Eccentric Weight Housing Oil - Change
1-87
